Author |
Message |
ffc57
Newbie
Joined: Oct 24, 2007
Posts: 16
|
Posted:
Fri Mar 19, 2010 4:04 pm |
|
Hello,
Any help would be greatly appreciated.....
Switched my rear wiper on a few days ago and it moved 90 degrees to vertical position then stopped.
Checked fuse - OK.
Checked volts on the 4 cores at the connector at the rear wiper motor assembly and they remain the same whatever the position of the steering column stalk.
I want to check the relay controlling the rear wiper but do not know where it is located. Does anybody know where it is ?
Does anybody have a copy of the wiring diagram for the rear wiper ?
Cheers,
FFC57 |
_________________ 1987 Audi 80 1.8S, 148,000 miles, (sold)
2003 Audi A6 Avant 1.9TDi SE, 128,500 miles, barely run in, 50mpg |
|
|
|
monkeyboyuk
Site Moderator
Joined: Aug 11, 2008
Posts: 1652
|
Posted:
Fri Mar 19, 2010 4:33 pm |
|
have a look at this a4 thread, most likely a similar cause link>> |
|
|
|
|
PaddleDoc
Newbie
Joined: Jan 12, 2010
Posts: 17
|
Posted:
Sun Aug 15, 2010 10:27 pm |
|
Did you get this fixed?
Had the same problem, easy fix once you get the trim off.
Dave F |
|
|
|
|
ffc57
Newbie
Joined: Oct 24, 2007
Posts: 16
|
Posted:
Sat Nov 20, 2010 7:59 am |
|
|
|
|
PaddleDoc
Newbie
Joined: Jan 12, 2010
Posts: 17
|
Posted:
Sat Nov 20, 2010 12:37 pm |
|
Hi ffc57,
Think it could be the other way round - I believe the the pipe is meant to rotate with the arm, the water tube rotating joint is at the rear of the wiper motor as part of the right angle plastic connector, suspect the silicon stopped it from rotating and the pipe fractured where the corrosion had weakened it.
My pipe didn't break but a leaking seal allowed washer fluid into the gearbox which rusted it solid, once I'd free'd & cleaned that up its worked OK (that was 2 years ago).
Regards
Dave |
|
|
|
|
waleeed12
Newbie
Joined: Mar 24, 2016
Posts: 2
|
Posted:
Thu Mar 24, 2016 6:06 am |
|
break but a leaking seal allowed washer fluid into the gearbox which rusted it solid, once I'd free'd & cleaned that up its worked OK (that was 2 years ago). |
_________________ waleeeed |
|
|
|
waleeed12
Newbie
Joined: Mar 24, 2016
Posts: 2
|
Posted:
Thu Mar 24, 2016 6:08 am |
|
break but a leaking seal allowed washer fluid into the gearbox which rusted it solid, once I'd free'd & cleaned that up its worked OK (that was 2 years ago).
== www.solitairecardgame.org == |
|
|
|
|
|
|
View next topic
View previous topic
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You can attach files in this forum You can download files in this forum
|